Fabrication of 3D Ni nanosheet array on Crofer22APU interconnect and NiO-YSZ anode support to sinter with small-size Ag nanoparticles for low-temperature sealing SOFCs

A novel low-temperature sealing method was developed to seal solid oxide fuel cells. The 3D Ni nanosheet array was pre-fabricated on faying surfaces of Crofer22APU interconnect and NiO-YSZ anode-support. Then it was covered with Au film without changing its morphology. This special nanostructure improved sintering efficiency between Ag nanoparticles and substrates. A dense joint was obtained at the low-temperature between 250 °C–300 °C. This method effectively avoided the oxidation of interconnect during sealing. When joints were sealed at 300 °C, the shear strength reached 16 MPa. The fracture was mainly located in the central Ag layer, presenting a significant plastic deformation. Due to the effective protection of Ni layer, joints also possessed excellent oxidation resistance in oxidizing atmosphere at 800 °C for 400 h. After high-temperature oxidation, the shear strength was increased to 23 MPa, revealing an increasement of 43.8% compared with the as-sealed condition (16 MPa). This sealing method has great potential in sealing solid oxide fuel cells. It also can be extended to seal other energy-conversion devices.     

裴沟煤矿典型断裂构造带水化学变化特征

断裂运动是错综复杂的地质作用，物质组成的变化能够通过水质中阴阳离子含量直观表现。以裴沟煤矿近20年来的突（涌）水点化验数据为依据探究各含水层水化学普遍性质，发现阳离子含量和矿化度可以作为水源判别的重要指标，以典型构造浮山寨断层为对象研究断裂构造带水化学变化特征，结果显示距离断裂构造带越近，水中Ca²⁺+Mg²⁺含量减小、Na⁺+K⁺含量增大、矿化度降低，揭示断层两盘不同含水层间水掺和程度。     

海水淡化用空心锥喷嘴喷淋性能理论及实验研究

设计开发一种具有高通量、低流阻特征的空心锥喷嘴,并通过理论与实验方法研究空心锥喷嘴的喷淋性能,基于准自由涡理论建立空心锥喷嘴内部流体流动的数学模型,阐明流量系数、喷淋锥角、喷嘴流量与喷嘴结构参数之间的定量关系,并利用多效蒸馏海水淡化喷淋实验台对理论计算结果进行实验测试和验证。研究结果表明:正常工作状态下喷嘴流量系数、喷淋锥角、喷淋流量等参数理论值与测量值之间的误差小于5%,验证了设计模型的准确性。同时根据实验测试数据,拟合得到该类型空心锥喷嘴喷淋锥角与雷诺数之间的经验公式,可为蒸馏海水淡化用大流量空心锥喷嘴的结构设计、工艺选型提供理论指导和数据支持。     

Effect of neodymium substitution on crystalline orientation,microstructure and electric properties of sol-gel derived PZT thin films

Pb(Nd_xZr_0.52Ti_0.48)O₃ (PNZT) (x = 0%, 1%, 2%, 3%, 4%, 5%) thin films were prepared by sol-gel process to investigate the effects of neodymium substitution on crystalline orientation, microstructure and electric properties of lead zirconate titanate (PZT) films. X-ray diffraction (XRD) and scanning electron microscope (SEM) analysis showed that PNZT films with Nd doping concentration below 3% exhibited dense perovskite structure with (100) preferred orientation. The average grain size of PNZT films decreased as the Nd substitution increased. The maximum dielectric constant, remnant polarization and minimum coercive field were obtained in 2% Nd-doped PZT films. Fatigue resistance was also improved significantly with 2% Nd dopant.     

基于数值微分核脉冲信号数字处理方法

核反应堆核测量系统测量探测器输出的核脉冲信号，该信号后沿拖尾很长，在计数率较高时容易产生信号堆积和基线漂移等问题，导致源区计数率测量上限仅能达到105 Hz左右。文中基于数值微分方法，采用数字处理技术，在时域上分析了核脉冲信号经过前置放大、信号成形、低通滤波和脉冲甄别后的输出，并利用探测器实测信号进行了仿真。仿真结果表明，基于数值微分的数字处理方法可以实现相邻0.4 μs脉冲信号的识别和测量，将源区测量计数率上限提升到2×106 Hz以上。      

Low Li ion diffusion barrier on low-crystalline FeOOH nanosheets and high performance of energy storage

Nano Research - To obtain symmetric supercapacitors (SCs) with high energy density, it is critical to fabricate an electrode with wide potential window and excellent capacitive performance. Herein,...     

4140钢弯壳体断裂原因分析和改进措施

某钻具厂生产的一个批次的4140钢螺杆钻具弯壳体出现较多断裂。通过化学成分、力学性能和显微组织分析对失效弯壳体断裂原因进行了研究,并相应优化了热处理工艺。结果表明:弯壳体失效断裂主要原因是由于淬火过程中未淬透,导致显微组织存在大量条状和块状铁素体,未淬透的组织导致材质的强度、硬度和冲击性能较差,从而导致断裂。采用优化的淬火工艺,材料寿命达到了正常水平。